PeterPan
Torque Junkie
Hello guys,
My ICE knowledge is somewhat limited beyond the basics and I hoping that some sage wisdom may come my way...
The car in question is TINY and so big sounds are not necessary, however...
I installed a head unit and comment speakers (there car comes with no stereo as standard) anyway...
The alpine head unit is load enough from its built in amp and 4x50w output, the components are just about loud enough but lacking bass.
I want to add more bass, and hopefully the components will perform better then if they are not having to handle the low notes.
What I am thinking to do is to add a small passive bass tube inbetween the footwwells and power it with a bridged 2x50w output from the head unit.
As far as I can understand, this will work but I will need to use passive crossovers between the head unit and the speakers.
So my outputs will be as follows:
*Front Left output - passive crosser - component speaker
*Front right output - passive crossover - component speaker
*L&R rear channels bridged - passive crossover - bass tube
Will this work ok?
Is this the best solution?
Any other suggestions welcome...
My ICE knowledge is somewhat limited beyond the basics and I hoping that some sage wisdom may come my way...
The car in question is TINY and so big sounds are not necessary, however...
I installed a head unit and comment speakers (there car comes with no stereo as standard) anyway...
The alpine head unit is load enough from its built in amp and 4x50w output, the components are just about loud enough but lacking bass.
I want to add more bass, and hopefully the components will perform better then if they are not having to handle the low notes.
What I am thinking to do is to add a small passive bass tube inbetween the footwwells and power it with a bridged 2x50w output from the head unit.
As far as I can understand, this will work but I will need to use passive crossovers between the head unit and the speakers.
So my outputs will be as follows:
*Front Left output - passive crosser - component speaker
*Front right output - passive crossover - component speaker
*L&R rear channels bridged - passive crossover - bass tube
Will this work ok?
Is this the best solution?
Any other suggestions welcome...