If you do this properly
it will look Cool
Things you will need:
1. Carbon Fiber wrap (cheap enough off eBAY)
2. Sharp precision knives
3. Hair Dryer
4. Thick cardboard - so you don't cut into the table
5. Thin cardboard - to make a template
6. TIME - Lots of
First find a piece of your car / item to wrap - give it a good clean with a tiny bit of washing up liquid - make sure it's completely dry, so the carbon can stick properly.
Make sure you have lots of time for any item you want to do - if you rush this - it WILL look rubbish, which defeats the object of doing it.
I'll show you how i wrapped my Cars remote fob...
Chose the right blade - smallest the better
Cut the Carbon down to the size required
Place them on the thick cardboard - ready to cut
Use a thin piece of cardboard, to make a template
Use the template, to cut out the carbon wrap
Once cut out - lay over the fob, then slowly take the back off, starting at the top, gently push it on, making sure there aren't any bubbles.
Use the hair dryer to stick / help it round corners, contours of the object.
Use the small knife (very gently) to cut out the ring part of the fob.
and you end up with this:
Hope this helps
it will look Cool
Things you will need:
1. Carbon Fiber wrap (cheap enough off eBAY)
2. Sharp precision knives
3. Hair Dryer
4. Thick cardboard - so you don't cut into the table
5. Thin cardboard - to make a template
6. TIME - Lots of
First find a piece of your car / item to wrap - give it a good clean with a tiny bit of washing up liquid - make sure it's completely dry, so the carbon can stick properly.
Make sure you have lots of time for any item you want to do - if you rush this - it WILL look rubbish, which defeats the object of doing it.
I'll show you how i wrapped my Cars remote fob...
Chose the right blade - smallest the better
Cut the Carbon down to the size required
Place them on the thick cardboard - ready to cut
Use a thin piece of cardboard, to make a template
Use the template, to cut out the carbon wrap
Once cut out - lay over the fob, then slowly take the back off, starting at the top, gently push it on, making sure there aren't any bubbles.
Use the hair dryer to stick / help it round corners, contours of the object.
Use the small knife (very gently) to cut out the ring part of the fob.
and you end up with this:
Hope this helps