hi can anyone help me plz i own a rover 620ti on 99 plate. its all standerd . and done 128k , but my batterys keeps going flat after new ones fitted. like 3 days only then new one . wat can that be . i tested it 12.7 volts car off. thanks
hi can anyone help me plz i own a rover 620ti on 99 plate. its all standerd . and done 128k , but my batterys keeps going flat after new ones fitted. like 3 days only then new one . wat can that be . i tested it 12.7 volts car off. thanks
i use to have a 4000 watts amp and sub but i took it out after the battery went. and no lights on dash, how can i test it on volt meter that there is no power leaking over night. coz i have to buy a battery every 4 days . so i disconnect it from the battery all wires.
yeh mate with being off 12.7 volts and then when i started it running its 13.3 wat can it be
no mate it runs no where near that mark. so how do i test the alternator .
yeh its got standerd alarm and stereo. i took the amp out of car but wires still in boot with tape around it.
honest mate i tryed all that . yeh things works in car i off the inside light . how do i try to test if anything is running overnight. is there a test for volt meter or something
its ok mate . no i mean like the light works inside car when i open the doors ,but if i drive the car then leave it for coupe of hours it goes flat.
You need to test your alternator mate. I've found this guide on how to do it: http://www.carbasics.co.uk/How_to_test_your_alternator.htm
If not, then like herb says, it could easily be a (possibly hidden) loose wire somewhere.
yes am having same probs mate how did u find ur fault where did u find it. yes i can use meter testers wat do i test
do you know how to check continuity with a multimeter ???yes am having same probs mate how did u find ur fault where did u find it. yes i can use meter testers wat do i test
no mate testing continuity isnt done through measuring the voltage it basicly allows you to test if their is a break in the circuit/wireyes how do i set it on continuity settings wats the volts called on meter. dc 20
sorry mate can i test the same on temp sensors and others sensors work. with same mode or not
i dont think my temp sensor works coz am running like 7 miles to a gallon
yeh it works when its really hot. but wat can that be lamba sensors is ok.
doesnt look like it is. it drives like normal but smokes when i start it up in mornings
sorry mate not really sure what you mean but testing for continuity is a long winded and boring process and im not really sure how to explain it mate it is basically testing most of the wires by connecting the probe to 1 end tracing the wire then connecting the other probe to the other end of the wire and seeing if you get the beep from the meter (just a little tip you will need a couple of meters of wire speaker wire is sufficient for when you have to test the longer wires)yeh sorry i get u now yes i got the digital 1 . so i leave it on beep mate for fuses and break in wires. wat if i take 1 wire off the battery and put my volt test on the end of it will that show me anything
Thread starter | Title | Forum | Replies | Date |
---|---|---|---|---|
A | 620ti help | 600 | 19 | |
A | Testing a Lambda sensor 620Ti | 600 | 28 | |
620ti Forum? | 600 | 4 | ||
Where's all the 620ti owners? Any out there? | 600 | 10 | ||
Engine fan 620ti | 600 | 19 |