A Arutha19 Wrench Pro Points 56 Location Scotland, Glasgow Car 2001 Corsa 1.0 19 July 2010 #1 I cannot find the clutch resevoir on my mates 1998 93 2.0t. Does anyone know where it is?
turbonutter69 TC ModFather Moderator Points 692 Location Alone in the dark. Car Insignia SRI. 20 July 2010 #2 Hydraulic clutches don't usually have a resevoir IIRC they run off the brake master cylinder and have a slave cylinder.
Hydraulic clutches don't usually have a resevoir IIRC they run off the brake master cylinder and have a slave cylinder.
A Arutha19 Wrench Pro Points 56 Location Scotland, Glasgow Car 2001 Corsa 1.0 20 July 2010 #3 Thanks =) So if you were changing the clutch would you still need to bleed the system? If so then how?
Thanks =) So if you were changing the clutch would you still need to bleed the system? If so then how?
L lutonmatt The Torque Meister Points 197 Location chatham kent Car 82 trans am kitt 20 July 2010 #4 you bleed the clutch slave same as you do the brakes pump pump pump slowly until you see most of the air gone then lock the nipple up few pumps hold down undo the nipple let that lot out job done normaly some take a bit longer others quicker
you bleed the clutch slave same as you do the brakes pump pump pump slowly until you see most of the air gone then lock the nipple up few pumps hold down undo the nipple let that lot out job done normaly some take a bit longer others quicker
A Arutha19 Wrench Pro Points 56 Location Scotland, Glasgow Car 2001 Corsa 1.0 21 July 2010 #5 Thanks very much for all the advice guys =)