Country Bumpkin
Track Warrior
Whilst building another engine today i wondered if any of you lot would be interested in some tech stuff along the lines of using plasti-gauge to measure the clearance on crank bearings, measuring and gapping piston rings etc ?
Unfortunately i didn't take any phots as my brainwave didn't occur until the bottom end was built and i was putting the heads on. It is something i could do at some stage though if there was enough interest. The amount of full engine builds i do is obviously dependent on demand but it's normally a couple a month so it wouldn't take too long to put something together. In fact it would probably take ages to get everything uploaded but i could add bits to a topic once i had started it.
I have another engine waiting for me to strip and rebuild anyway so it's not too far off, just got to get this current one out of the engine shop.
Just a thought.
Unfortunately i didn't take any phots as my brainwave didn't occur until the bottom end was built and i was putting the heads on. It is something i could do at some stage though if there was enough interest. The amount of full engine builds i do is obviously dependent on demand but it's normally a couple a month so it wouldn't take too long to put something together. In fact it would probably take ages to get everything uploaded but i could add bits to a topic once i had started it.
I have another engine waiting for me to strip and rebuild anyway so it's not too far off, just got to get this current one out of the engine shop.
Just a thought.