Hutch106
Wrench Pro
Once home i need to test the resistance readings for my fuel sender unit, this is required to work out the pull up resistor required to use my Dash2 unit for fuel level etc.
Three pins on the unit, i'm guessing
GROUND
INPUT VOLTAGE
OUTPUT VOLTAGE
???????
Or is one of them a low level switch circuit?
I'm just wondering which pins i need to measure the resistance at
5 ltrs
10 ltrs
15 ltrs
and so on until full (45ltrs)
Peugeot 106 OEM sender unit.
Any help would be greatly received
Hutch
Three pins on the unit, i'm guessing
GROUND
INPUT VOLTAGE
OUTPUT VOLTAGE
???????
Or is one of them a low level switch circuit?
I'm just wondering which pins i need to measure the resistance at
5 ltrs
10 ltrs
15 ltrs
and so on until full (45ltrs)
Peugeot 106 OEM sender unit.
Any help would be greatly received
Hutch