Hunkyfunky720
Newbie
Hi i new here.
I have just had my c20let redtop engine freshly rebuiltlueprinted.
It has a fully forged internals with steel H beam rods and JP low compression pistions machined to suit my stage 3 k16 hybrid Turbocharger.
It has a coscast head with fully gas flowed and ported head ports and a pair or kent uprated cams (fast road).
I have installed a walbro 255 in tank fuel pump and all new injection hoses neoprene.
I have a 3inch top hat with 2.5inch alloy boost pipes running through a FMIC.
The ECU is a regal auto sport phase 4 with power wheel. It came with a 3.5 bar FPR and advised to run the Bosch yellow injectors.
I have yet to run in the engine firstly but the engine builder suggested a remap on my chip set but the problem is i cant find anyone resealable to carry out the tweak to my exsisting map.
Can i adjust the parameters of my set up manually like bigger injectors and a boost controller ?
Its running 21 psi over boost and i have a wideband sensor installed and the fuelling looks good before i had my engine rebuilt it was running 290 bhp im hoping to get 300+ bhp now after the run in. Can anyone advise me on chips or injector specs to use safely.
Many thanks and best regards
I have just had my c20let redtop engine freshly rebuiltlueprinted.
It has a fully forged internals with steel H beam rods and JP low compression pistions machined to suit my stage 3 k16 hybrid Turbocharger.
It has a coscast head with fully gas flowed and ported head ports and a pair or kent uprated cams (fast road).
I have installed a walbro 255 in tank fuel pump and all new injection hoses neoprene.
I have a 3inch top hat with 2.5inch alloy boost pipes running through a FMIC.
The ECU is a regal auto sport phase 4 with power wheel. It came with a 3.5 bar FPR and advised to run the Bosch yellow injectors.
I have yet to run in the engine firstly but the engine builder suggested a remap on my chip set but the problem is i cant find anyone resealable to carry out the tweak to my exsisting map.
Can i adjust the parameters of my set up manually like bigger injectors and a boost controller ?
Its running 21 psi over boost and i have a wideband sensor installed and the fuelling looks good before i had my engine rebuilt it was running 290 bhp im hoping to get 300+ bhp now after the run in. Can anyone advise me on chips or injector specs to use safely.
Many thanks and best regards