Recent content by minitec

as above really, has anybody used the k20 aftermarket TB's I've seen quite a few on ebay between 70 and a 100 pounds are they any good ? are they worth the money and do they actually do the job they are intended for? They look ok in the photos but pictures can be deceiving just wondered what...

little update i think i can get away with just changing the throttle body for the k20a2 item along with engine loom and oil pressure and crank sensor. then its a question of using a after market ecu, hondadata kpro or similar (fingers crossed lol) the car loom can then be built around the ecu as...

thanks for that i am gonna go with the k20a2 set up and use the intake manifold and cable throttle body, also the engine wiring loom. Im lead to believe i will also have to change the crank and oil pressure sensors.The exhaust is especially made for the set up so should be ok. Mechanically it...

i`ll post up up dates on here as and when i get more info, if anyone reading this can shed any light on the subject please feel free to share lol. could anyone tell me what (apart from the TB and intake manifold) are the main mechanical differences between the two engines FN2 k20z4 and the...

thanks for the reply i did a little research today and i think it involves swapping the intake manifold and obviously the throttle body and engine loom for the k20a/a2 items, and probably a couple of sensors, i suspect there might be a little more to it than this but as i said before im not...

hi all this is my first post in this forum, so Hello!. Im going to be fitting a k20z4 in my classic mini and was wondering if its possible to convert the drive by wire set up to the cable throttle (as in the K20a2) the car is just a rolling shell at the moment no wiring, ECU, etc so ill be...